busteropk.blogg.se

It is observed only in certain OFDM symbols of measurement time resources,

NR carrier RSSI is linear average of the total received power (Watts).

Made over same set of resource blocks (RBs). The measurements in N (Numerator) and D (Denominator) shall be Here N refers to number of resource blocks in

It is defined as ratio of N x SS-RSRP/NR carrier RSSI.

SS-RSRQ stands for Secondary synchronization Signal Reference Signal Received Quality.

RRC_CONNECTED inter-frequency 5G NR RSRQ | SS-RSRQ, CSI-RSRQ

For frequency range 2 (FR2), CSI-RSRP shall be measured based on the combined signal from antenna elements corresponding to a given receiver branch.

For frequency range 1 (FR1), the reference point for the CSI-RSRP shall be the antenna connector of the UE.

For CSI-RSRP determination CSI reference signals transmitted on antenna port 3000.

Resource elements which carry CSI reference signals configured for RSRP measurements.

CSI-RSRP stands for CSI reference signal received power.

For frequency range 2, SS-RSRP shall be measured based on the combined signal from antenna elements corresponding.For frequency range 1, the reference point for the SS-RSRP shall be the antenna connector of the UE.The measurement time resource(s) for SS-RSRPĪre confined within SS/PBCH Block Measurement Time Configuration (SMTC) window duration.Resource elements which carry secondary synchronization signals. It is defined as linear average over the power contributions (in Watts) of the.

SS-RSRP stands for SS reference signal received power.FR1 supports transmission BWs from 5 MHz (min.) to 100 MHz(max.) where asįR2 supports 50MHz (min.), 100MHz, 200 MHz and 400 MHz(max.). FR1 uses subcarrier spacing of 15/30/60 KHz where asįR2 uses 60/120 KHz. FR1 (Frequency Range 1) lies from 450 MHz to 6000 MHz andįR2 (Frequency Range 2) lies from 24250 MHz to 52600 MHz. ➤As a result RSRP, RSRQ and SINR are associated with SS and CSI. Instead SS (Synchronization Signal) and CSI (Channel State Information) are used. Refer LTE RSRP vs RSRQ > for more information. ➤In LTE, RSRP and RSRQ are associated with CRS (Cell Specific Reference Signal). It defines SS-RSRP, CSI-RSRP, SS-RSRQ, CSI-RSRQ, SS-SINR and CSI-SINR. The definitions and use of RSRP, RSRQ and SINR in 5G NR are also mentioned.RRC Information Elements (IEs) which carries these measurements This page mentions RSRP, RSRQ and SINR measurements used in 5G NR system. 5G NR RSRP RSRQ SINR measurements | Define RSRP RSRQ SINR